Board & Batten

Look what I've been up to?
This weekend I put board & batten in our front room!

We bought primed mdf from Home Depot:
Header: (2) 5-1/2' x 6'
Verticals: (11) 1-1/2 x 8'

After a tutorial from da hubbs on how to use a chop saw and a nail gun, I went to work.

It took a full day, but it was totally do-able and FUN!
Here's how to do it:

1. MEASURE
Measure out the wall for the vertical boards, using painter's tape to mark it. Making sure that the boards won't cover any outlets or light switches. There are 10.5 inches between each vertical board. But I really only measured every 12" keeping in mind that the mark would line up to the left of each board. 12"-1.5"(width of board)=10.5". Then I marked where the header would go, using a level and pencil.


2. HEADER
Measure the header (I used two boards) and cut the edges at 45 degree angles where they join. Using liquid nails I glued the header in place, checking with the level to make sure it was all good. I used the T-support to hold it in place so I could nail it. (Holy cow mdf is heavy!) I used 1.25" finishing nails. Then with a pencil I marked on the bottom on the header the 12" increments for the vertical boards.


3. MEASURE & CUT VERTICALS
Line up each board to the marks on the header. Number each board on the back along with the length it needs to be cut to. Measure each board individually because the may need to be cut at different lengths. (I didn't want the vertical boards to hang over the existing base board, so I cut 45 degree angles leaving 0.25" blunt edge, so it didn't come to a point, at the bottom of each board. That sounds confusing so refer to the picture below).

When the bottom cuts are done, measure and mark each board according to their individual measurements and cut them to length.

4. GLUE & NAIL VERTICALS
Line up each vertical board to their place and make sure they'll fit. One at a time, glue the board with liquid nails, lining it up to the mark on the header and checking with a level. When it's good and level, nail it in place.

5. CAULK & PAINT
Fill in nail holes and joints with putty. Caulk around all the boards with paint-able caulk. Sand the putty places. Tape off the walls and paint. And then paint again...

TA-DA!


My decorations are still a work in progress.
As soon as my basement is finished the piano is moving downstairs and I hope to replace it with a cute chair and lamp.

Oh, and a hutch will replace my armoire...some day.
I search ksl classifieds weekly for "the one", to refinish just the way I want.